Low-Reverse Band (Rear)

Low-Reverse band adjusting screw is located on rear servo lever. Transmission oil pan must be removed to provide access to band adjusting screw. See Fig 1 .

Fig 1: Low-Reverse Band Adjustment (Rear) Screw Location

1. Drain transmission and remove oil pan. Loosen band adjusting screw lock nut about 5 turns. Ensure adjusting screw turns freely in case. Tighten adjusting screw to 41 INCH lbs. (4.6 N.m).
2. Back off adjusting screw specified number of turns given in LOW-REVERSE BAND ADJUSTMENT  . Hold in this position and tighten lock nut. Install oil pan and fill transmission with fluid.