LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2004 >> Silhouette GL >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Parking Brake System) >> Repair Instructions >> Park Brake Shoe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the park brake shoe to the actuator (4).
  2. Install the park brake shoe and actuator (4) onto the backing plate (7).
  3. Position the park brake shoe, actuator (4), and backing plate (7) over the rear hub.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the park brake cable bracket (8) and the two retainers (9).

    Tighten:  Tighten the bracket retainers to 14 N.m (124 lb in).

    5. Fig 1: Identifying Parking Brake Components
    GM177182Courtesy of GENERAL MOTORS CORP.
  5. Install the rear hub. Refer to Wheel Bearing/Hub Replacement - Rear in Rear Suspension.

    The rear hub, backing plate, park brake cable bracket, and park brake actuator will be installed as an assembly.

  6. Install and connect the rear park brake cable to the bracket at the rear wheel.
    7. Fig 2: View Of Rear Park Brake Cable & Wheel Speed Sensor Electrical Connector
    GM741967Courtesy of GENERAL MOTORS CORP.
  7. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel.
  8. Install the rear rotor. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
  9. Install the rear caliper bracket. Refer to Brake Caliper Bracket Replacement - Rear in Disc Brakes.
  10. Install the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  11. Adjust the park brake system. Refer to Park Brake Adjustment .
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals