LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2004 >> Bravada RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1744 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement (5.3L Engine) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • The negative battery cable must not be connected to the battery prior to the installation of the engine harness ground terminal to the engine block.
  • The negative battery cable must not be connected to the battery prior to the installation of the instrument panel harness and the engine harness to the powertrain control module.
    Fig 1: View Of Ground Terminal Bolt
    GM899615Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the cable to the engine harness conduit.
  2. Install the ground terminal bolt to the engine block.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    3. Fig 2: View Of Generator Cable Boot, Head, Nut & Bolt
    GM899614Courtesy of GENERAL MOTORS CORP.
  3. Install the ground cable clip to the shock tower.
  4. Install the ground cable bolt (4) that secures the harness to the shock tower.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    5. Fig 3: Identifying Battery Cable Components
    GM899613Courtesy of GENERAL MOTORS CORP.
  5. Install the ground terminal bolt (3) that secures the harness to the front fender.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  6. Connect the negative battery cable (5). Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals