LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2004 >> Bravada RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1743 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Vehicle Rollover Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vehicle Rollover Sensor
    GM1526913Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts securing the rollover sensor to the floor panel.

    Tighten:  Tighten the screws to 10 N.m (88 lb in).

  3. Install the rear carpet. Refer to Carpet Replacement - Rear (TrailBlazer EXT, Envoy XL) or Carpet Replacement - Rear (Envoy XUV) or Carpet Replacement - Rear (Trailblazer, Envoy, Rainier) in Interior Trim.
scientia non olet · About LEMON Manuals