LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2004 >> Bravada RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1743 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Passenger Presence System Replacement - Front >> Installation Procedures

Installation Procedures

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Cushion Frame Bladder Retainers
    GM811858Courtesy of GENERAL MOTORS CORP.
  1. Install the inflatable restraint passenger presence system to the seat.
  2. Install the push-in retainers (1) that hold the bladder to the seat cushion frame.
    3. Fig 2: View Of Electronic Control Unit & Pressure Switch
    GM811855Courtesy of GENERAL MOTORS CORP.
  3. Install the pressure sensor (2) to the bottom of the passenger seat cushion frame.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the bolts that retain the ECU (1) to the bottom the passenger seat cushion frame.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  5. Connect the electrical connectors.
  6. Install the seat cushion trim cover and pad.
  7. Re-zero the inflatable restraint passenger presence system. Refer to Passenger Presence System Programming and Setup in Programming and Setup.
scientia non olet · About LEMON Manuals