LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2004 >> Bravada RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1739 (Interior Trim) >> Repair Instructions >> Sunshade Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If the vehicle is equipped with lighted sunshades, perform steps 2 through 8:
    2. Fig 1: Hot Melting Electrical Connectors
    GM769574Courtesy of GENERAL MOTORS CORP.
  2. Lower the headliner in order to gain access to the wire harness.
  3. Position the sunshade to the headliner.
  4. Connect the sunshade electrical connector to the headliner harness.
  5. Using a glue gun, hot melt the electrical connectors (1) to the headliner substrate, ensuring the connectors are securely attached to the substrate.
    6. Fig 2: Wire Harness Seated Into Sunshade Wire Harness Channel
    GM672380Courtesy of GENERAL MOTORS CORP.
  6. Route the wire harness until fully seated into the sunshade wire harness channel located on the pivot arm.
    7. IMPORTANT: If the wire harness retaining clip is removed from the sunshade for any reason, a new retaining clip must be installed.
    Fig 3: Wire Harness Retaining Clip
    GM672466Courtesy of GENERAL MOTORS CORP.
  7. Position the wire harness retaining clip between the headliner and the roof panel.
  8. Position the index tabs on the wire harness retaining clip to the pivot arm and install the clip until fully seated.

    With the wire harness retaining clip installed, the sunshade should remain attached to the headliner.

    9. Fig 4: Removing Inboard Retainer
    GM672434Courtesy of GENERAL MOTORS CORP.
  9. Position the inboard retainer (1) to the roof panel.
    10. NOTE: Refer to Fastener Notice in Cautions and Notices.
  10. Install the inboard retaining screw.

    Tighten:  Tighten the screw to 1.2 N.m (10 lb in).

    11. Fig 5: Pivot Arm Tab To Roof Panel Slot
    GM672363Courtesy of GENERAL MOTORS CORP.
  11. With the sunshade parallel to the windshield, index the pivot arm tab to the roof panel slot.
    12. Fig 6: Sunshade Pivot Arm
    GM672372Courtesy of GENERAL MOTORS CORP.
  12. Apply and maintain upward pressure to the pivot arm while rotating the sunshade parallel to the side window. The sunshade arm should appear flush with the bezel.
  13. Rotate and clip the sunshade to the inboard retainer.
  14. Ensure the pivot arm retaining tabs are fully seated to the roof panel.
  15. Install the front assist handle to the roof panel. Refer to Assist Handle Replacement .
  16. Install the windshield garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar .
  17. Install the center pillar trim panel. Refer to Garnish Molding Replacement - Center Pillar .
  18. Return the bucket seat to an upright position.
scientia non olet · About LEMON Manuals