Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Bulkhead Connector

Courtesy of GENERAL MOTORS CORP.

Install the lumbar switch to the switch bezel, verifying that the retaining tabs are fully seated. Refer to Lumbar Switch Replacement - Front
Install the seat switches to the switch bezel, verifying that the retaining tabs are fully seated. Refer to Seat Switch Replacement - Power

Fig 2: Seat Switch Bezel Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the switch bezel to the seat with the 3 screws.
Tighten: Tighten the front seat switch bezel screws to 3 N.m (26 lb in).