LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2004 >> Bravada AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1738 (Entertainment Systems) >> Repair Instructions >> Radio Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Alignment Locator
    GM718020Courtesy of GENERAL MOTORS CORP.
  1. Position the radio to the I/P.
  2. Connect the electrical connectors to the radio.
  3. Connect the radio antenna cable to the radio.
  4. Position the radio rear alignment locator (1) into the I/P substrate.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 3 screws that retain the radio to the I/P.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC) or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Buick) or Trim Plate Replacement - Instrument Panel (I/P) Accessory (GMC) or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Buick) in Instrument Panel, Gages, and Console.
  7. Install the lower closeout/insulator panel (GMC only). Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower (GMC/Chevrolet) in Instrument Panel, Gages, and Console.
  8. If a replacement radio is installed, setup the radio. Refer to Control Module References in Computer/Integrating Systems.
scientia non olet · About LEMON Manuals