LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2002 >> Intrigue GLS >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Repair Instructions >> Brake Fluid Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
NOTE: Refer to FASTENER NOTICE
  1. Install the brake pressure sensor to the EBCM in the vehicle.

    Tighten 

    Tighten the pressure sensor to 22 N.m (16 lb ft).

  2. Connect the brake pressure sensor electrical connector.
  3. Position the EBCM back into the support bracket and tighten the retaining nuts.

    Tighten 

    Tighten the retaining nuts to 10 N.m (89 lb in).

  4. Perform the Diagnostic System Check - ABS  to verify the repair.
scientia non olet · About LEMON Manuals