Park/Neutral Position Switch
NOTE:
The following procedure is for vehicles that have not had the switch removed or replaced. If the switch has been removed or replaced, see PARK/NEUTRAL POSITION SWITCH
under REMOVAL & INSTALLATION. Apply the parking brake. The engine must start in the Park and Neutral positions only. Check the switch for proper operation. If adjustment is required, proceed as follows:
- With an assistant in driver's seat, raise and support vehicle. The transmission must be in the Park or Neutral positions only.
- Loosen the switch retaining bolts and rotate the switch slightly, while the assistant attempts to start engine. After engine starts, turn engine off. Tighten PNP switch bolts to specification.
- See TORQUE SPECIFICATIONS . Ensure vehicle does not start in any range other than Park and Neutral. Replace the PNP switch if proper operation can not be achieved.