LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2002 >> Bravada AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Power Seat System >> Repair Instructions >> Memory Seat Control Module Replacement >> Installation Procedure

Installation Procedure

  1. Align and install the locating tabs on the seat control module with the seat pan.
  2. Connect the electrical connectors to the seat control module as necessary.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the screw that retains the seat control module to the seat pan.

    Tighten:  Tighten the screw to 3 N.m (26 lb in).

    Fig 1: Removing/Installing Seat Control Module Retaining Screw
    GM752957Courtesy of GENERAL MOTORS CORP.
  4. Install the seat pan to the seat assembly.
  5. Install the nuts which retain the seat pan to the seat assembly.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    Fig 2: View Of Underside Of Seat Adjuster Frame & Mounting Nuts
    GM752864Courtesy of GENERAL MOTORS CORP.
  6. Install the 3 seat switch bezel screws. Refer to Seat Switch Bezel Replacement .
  7. Calibrate the seat. Refer to Memory Seat Calibration Procedure .
scientia non olet · About LEMON Manuals