LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2001 >> Intrigue GL >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Control Modules >> Removal & Installation >> Electronic Brake Control Module >> Installation

Electronic Brake Control Module: Installation

CAUTION: Use correct fastener in correct location. Replacement fasteners must be correct part number for application. Fasteners requiring replacement or fasteners requiring use of thread locking compound or sealant are identified in service procedures. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage fastener. Use correct tightening sequence and specifications when installing fasteners in order to avoid damage to part and systems.
  1. To install, clean BPMV gasket surface with alcohol. Install NEW wave spring(s) in original location and position between EBCM and BPMV. Install EBCM to BPMV. Install NEW top mounting screws and tighten in an "X" pattern. Install NEW bottom screws and tighten all screws to 26 INCH lbs. (2.9 N.m).
  2. Connect pump motor connector at bottom of EBCM. Connect EBCM harness connector and push in lock tab. Turn ignition on, with engine off. Perform ANTI-LOCK BRAKE SYSTEM DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM.
scientia non olet · About LEMON Manuals