LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2001 >> Bravada >> Repair and Diagnosis (Single Page) >> Transmission >> Transfer Case >> Transfer Case - NVG 136 Removal & Installation >> Removal & Installation >> Transfer Case Shift Control Module >> Removal

Transfer Case Shift Control Module: Removal

  1. Remove the right front door sill trim plate from the vehicle by gently pulling it upward. Remove the right-side instrument panel sound insulator. Remove the body hinge pillar trim panel.
    Fig 1: Removing/Installing Right Hinge Pillar Trim Panel
    G00404682Courtesy of GENERAL MOTORS CORP.
    Fig 2: Removing/Installing Right Side Instrument Panel Sound Insulator
    G00404685Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Before performing the following service procedure, ensure that the ignition is in the off position.
    Fig 3: Locating Transfer Case Control Module Connectors
    G00404683Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the 2 wiring harness connectors from the transfer case control module.
  3. Remove the mounting nuts for transfer case control module to the retainer.
  4. Remove the transfer case control module from the mounting bracket.
    Fig 4: Removing/Installing Transfer Case Control Module
    G00404684Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals