LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 2000 >> Intrigue GL >> Repair and Diagnosis >> External Pages >> Different car >> Section 467 (Anti-Lock Brake System) >> Repair Instructions >> Wheel Speed Sensor Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The front wheel speed sensors and rings are integral with the hub and bearing assemblies.

If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly. Do not service the harness pigtail individually because the harness pigtail is part of the sensor. Refer to WHEEL BEARING/HUB REPLACEMENT - FRONT in Front Suspension.

  1. Raise and support the vehicle on a suitable hoist.
  2. Remove the front tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Disconnect the front wheel speed sensor jumper harness electrical connector (1).
    Fig 1: Disconnect Front Wheel Speed Sensor Jumper Harness Electrical Connector
    G01757554Courtesy of GENERAL MOTORS CORP.
  4. Remove the hub and bearing assembly (2). Refer to WHEEL BEARING/HUB REPLACEMENT - FRONT in Front Suspension.
    Fig 2: Remove Hub And Bearing Assembly
    G01757555Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals