Method 1 - No Tools Required
NOTE:
Once entering this procedure, programming the first transmitter erases all previous transmitters. You must program all transmitters. Program one vehicle at a time. One transmitter could be programmed into other vehicles that are also on program mode in close proximity.
In the event that a transmitter is lost, program the old and the new transmitters into the memory of the remote control door lock receiver. Up to 4 transmitters may be programmed.
- Sit in the driver's seat.
- Remove the ignition key from the ignition lock cylinder.
- Close all vehicle doors.
- Press and hold unlock on the door lock switch.
- While holding the door lock switch in the unlock position, insert and remove the ignition key twice. Do not rotate the ignition lock cylinder.
- Insert the ignition key a third time leaving the key in the ignition lock cylinder. The ignition must remain in the LOCK position for the rest of the procedure.
- Release the door lock switch. You will hear 3 chimes. This chime feedback indicates that transmitter programming is active.
- Press and hold the lock and unlock buttons at the same time on the keyless entry transmitter for 12 seconds. You will hear 2 chimes. This chime feedback indicates that the transmitter has been programmed successfully.
- Repeat step 8 for the remaining transmitters. There can be up to a total of 4 transmitters for each vehicle.
- Exit this procedure by removing the ignition key from the ignition lock cylinder.