LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Intrigue GL >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Removal & Installation >> Support >> Installation

Removal & Installation: Support: Installation

  1. Position the rear suspension support in place.
  2. Install the rear wheel spindle rod-to-rear suspension support bolts and nuts. Torque the rear wheel spindle rod-to-rear suspension support nuts to 103 ft. lbs. (140 N.m).
  3. Install the rear suspension support mounting bolts. Torque to specification. See TORQUE SPECIFICATIONS .
  4. Position the rear wheel spindle rod to the knuckle. Install the retaining bolts and nuts to the knuckle.
  5. Connect the brake hoses to the rear suspension support.
  6. Install the parking brake cables and the tensioner.
  7. Install the stabilizer shaft brackets to the rear suspension support.
    8. NOTE: Insert the bracket bolts facing rearward. Do not tighten the bolts at this time.
  8. Install the stabilizer shaft bracket bolts to the rear suspension support.
  9. Install the stabilizer shaft-to-stabilizer shaft link nuts. Torque to specification. See TORQUE SPECIFICATIONS .
  10. Connect the stabilizer shaft to the rear suspension support.
  11. Install the stabilizer shaft insulator bracket bolt. Torque to specification. See TORQUE SPECIFICATIONS .
  12. Lower the vehicle.
  13. Adjust the rear wheel alignment. See SPECIFICATIONS & PROCEDURES -- CARS -- EXCEPT .
scientia non olet · About LEMON Manuals