LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Intrigue Base >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel >> Removal & Installation >> Ignition And Start Switch Replacement >> Installation Procedure

Installation Procedure

  1. Install the ignition switch bracket to the ignition switch.
    2. Fig 1: Identifying Ignition Switch & Start Switch
    GM182725Courtesy of GENERAL MOTORS CORP.
  2. Install the bolts to the ignition switch bracket. Tighten the bolts to 6 Nm (53 lb in).
  3. Install the ignition switch into position through the IP cluster opening.
  4. Connect the electrical connectors to the ignition switch.
  5. Connect the pass lock electrical connector from the ignition switch.
  6. Connect the park/lock cable to the ignition switch.
  7. Install the bolts to the ignition switch. Tighten the ignition switch bolts to 6 Nm (53 lb in).
  8. Insert the key and turn the ignition switch lock cylinder to the ACC position.
  9. Align and press ignition switch lock cylinder into place.
    10. IMPORTANT: Ignition switch lock cylinder may previously have not rotated or was seized.
  10. If the ignition switch lock cylinder previously removed was seized or would not rotate, perform the following procedures:
    1. Install the new ignition switch lock cylinder as required by rotating both the cylinder and the ignition switch to the ON position.
    2. Push the ignition switch lock cylinder into the ignition switch housing until fully seated.
    3. It may be necessary to slightly depress the release button as it passes by the 9/32-inch hole previously drilled in the ignition switch housing.
  11. Remove the key from the ignition switch.
  12. Install the IP cluster.
  13. Install the HVAC control head.
  14. Install the radio.
  15. Connect the negative battery cable.
scientia non olet · About LEMON Manuals