LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Cutlass GLS >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> On-Vehicle Testing >> Engine Does Not Crank, Solenoid Clicks

Engine Does Not Crank, Solenoid Clicks

  1. Remove 20-amp F/P INJ fuse. F/P INJ fuse is located in underhood fuse block. Turn ignition switch to START position. Using a DVOM, measure voltage between battery positive and negative terminals. Crank engine for at least 15 seconds. If voltage is 9.6 volts or more, go to step 3). If voltage is less than 9.6 volts, go to next step.
  2. Load test battery. If battery fails load test, replace battery. If load test is okay, repair or replace starter motor.
  3. Using DVOM, measure voltage between battery negative terminal and engine block while cranking engine for 15 seconds. If voltage is less than 0.5 volt, go to next step. If voltage is 0.5 volt or more, clean negative battery cable connections and retest. If voltage is still 0.5 volt or more, replace battery negative cable.
  4. Using DVOM, measure voltage between battery positive terminal and starter solenoid terminal "B" (Black wire) while cranking engine for 15 seconds. If voltage is less than 0.5 volt, repair or replace starter motor assembly. If voltage is 0.5 volt or more, clean positive battery cable connections and retest. If voltage is still 0.5 volt or more, replace battery positive cable.
scientia non olet · About LEMON Manuals