LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Cutlass Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Power Door Lock System >> System Tests >> Power Door Locks Operate Normally But Automatic Lock Does Not Operate Properly Feature

Power Door Locks Operate Normally But Automatic Lock Does Not Operate Properly Feature

  1. Disconnect multifunction alarm module connector C1. Module is located behind left side of instrument panel, near steering column. Turn ignition switch to RUN position. Unlock door locks. Connect jumper wire between alarm module connector C1 terminal "P" (Light Blue wire) and voltage. See WIRING DIAGRAMS  . If power door locks operate when jumper is connected, go to next step. If power door locks do not operate when jumper is connected, repair open circuit in Light Blue wire.
  2. Turn ignition switch to RUN position. Position gear selector lever in Park position. Check voltage between connector C1 terminal "J", (Orange/Black wire) and battery voltage. If battery voltage is present, go to next step. If battery voltage is not present, check Orange/Black and Black/White wires for an open circuit. See WIRING DIAGRAMS  . If wiring is okay, replace transaxle range switch.
  3. Repeat step 2) with gear selector in Drive. If battery voltage is not present, replace multifunction alarm module. If battery voltage is present, check Orange/Black wire for a short to ground. If wire is okay, check replace transaxle range switch.
scientia non olet · About LEMON Manuals