LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1997 >> Regency >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Removal & Installation & Overhaul - 3.8L >> Ignition System >> Ignition Control Module (C(3)I) >> Removal & Installation

Removal & Installation

  1. Disconnect negative battery cable. Disconnect 14-way connector at ignition control module. Disconnect spark plug wires from coil pack. Remove 6 screws retaining coils to ignition control module. Tilt coil assembly back, and disconnect connectors between ignition coil and module. Remove coil pack.
  2. Remove screws and washers securing ignition control module to bracket. Remove ignition control module. To install, reverse removal procedure. Tighten retaining screws to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals