LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1997 >> LSS 3.8 1 >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Starting System) >> Bench Testing >> Solenoid Windings Tests >> Hold-In Windings Test

Hold-In Windings Test

WARNING: This page is about a different car, the 1998 Pontiac Bonneville, 1998 Oldsmobile Regency, 1998 Oldsmobile LSS, 1998 Oldsmobile Eighty-Eight, and 1998 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. If solenoid is not removed from starter motor assembly, disconnect field lead from terminal "M" on solenoid and insulate field lead from solenoid motor terminal. Connect an ammeter and switch in series with 12-volt battery and starter solenoid terminal "S" as illustrated. See Figure . Connect a voltmeter between solenoid terminal "S" and ground. Connect a carbon pile across battery.
  2. Turn switch on and quickly adjust carbon pile load until voltage reads as specified. See the HOLD-IN WINDINGS SPECIFICATIONS  table. Check ammeter reading. Turn off carbon pile and open switch. See the HOLD-IN WINDINGS SPECIFICATIONS  table. If amperage reading is not as specified, replace starter solenoid.
scientia non olet · About LEMON Manuals