LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1997 >> LSS 3.8 1 >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Cruise Control System) >> Testing >> Cruise Control Will Not Resume, Accelerate Or Tap-Up

Cruise Control Will Not Resume, Accelerate Or Tap-Up

WARNING: This page is about a different car, the 1998 Pontiac Bonneville, 1998 Oldsmobile Regency, 1998 Oldsmobile LSS, 1998 Oldsmobile Eighty-Eight, and 1998 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect cruise control module assembly connector. Turn ignition switch to RUN position. Turn cruise control switch to ON position. Using a test light connected to ground, probe cruise control module assembly connector (harness side) terminal "C" (Gray/Black wire). See WIRING DIAGRAMS  . While observing test light, press and hold cruise control switch in R/A position. If test light illuminates, go to next step. If test light does not illuminate, go to step 3).
  2. Ensure cruise control module assembly connector terminal "C" (Gray/Black wire) is clean and tight. If connection is okay, replace cruise control module assembly. See CRUISE CONTROL MODULE ASSEMBLY  under REMOVAL & INSTALLATION.
  3. Check for an open or short to ground in Gray/Black wire between cruise control module assembly and multifunction lever (cruise control switch). If Gray/Black wire is okay, replace multifunction lever (cruise control switch). See STEERING COLUMN SWITCHES article.
scientia non olet · About LEMON Manuals