Trouble Shooting Hints

On all models, note condition of SECURITY indicator light. If indicator stays on or flashes continuously, see ANTI-THEFT SYSTEM in appropriate ACCESSORIES & EQUIPMENT article. Check starter solenoid terminals and battery grounds. Check for proper installation of aftermarket electronic equipment. Perform self-diagnostic system test, to be certain no trouble codes are stored in PCM memory which may lead to misdiagnosis. See TESTS W/CODES article in ENGINE PERFORMANCE section.

Check 60-amp IGN-3 fuse in rear maxi-fuse block No. 2. See the COMPONENT LOCATION  table. If fuse is open, check for a short to ground in Yellow wire between ignition switch, instrument panel fuse block and starter enable relay connector terminal C1. Also check for short to ground in Purple wire between starter enable relay connector terminal A2 and starter solenoid terminal "S".