LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1997 >> Aurora >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Memory System >> Trouble Shooting >> Parallel Parking Assist Mode Inoperative

Parallel Parking Assist Mode Inoperative

  1. If diagnostic system check was performed, go to next step. If diagnostic system check was not performed, go to DIAGNOSTIC SYSTEM CHECK  .
  2. Disconnect Park/Neutral Position (PNP) switch connector. Connect fused jumper wire between PNP switch harness connector C1 terminals "B" (Pink wire) and "F" (Light Green wire). Turn ignition switch to RUN position. If right mirror moves down, go to step 5). If right mirror does not move down, go to next step.
  3. Remove fused jumper wire. Disconnect memory seat/mirror control module Blue 32-pin connector C1. Using DVOM, check resistance between PNP switch harness connector C1 terminal "F" (Light Green wire) and memory seat/mirror control module harness connector C1 terminal D13 (Light Green wire). If resistance is less than 5 ohms, go to next step. If resistance is not less than 5 ohms, go to step 6).
  4. Replace memory seat/mirror control module. See MEMORY SEAT/MIRROR CONTROL MODULE  under REMOVAL & INSTALLATION. Perform DIAGNOSTIC SYSTEM CHECK  .
  5. Replace PNP switch. Perform DIAGNOSTIC SYSTEM CHECK  .
  6. Repair open in Light Green wire between PNP switch and memory seat/mirror control module connector C1. Perform DIAGNOSTIC SYSTEM CHECK  .
scientia non olet · About LEMON Manuals