LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1996 >> Eighty-Eight Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control Systems Tests W/Codes >> Diagnostic Trouble Codes >> DTC P1134 - Ho2S Transition Time Ratio Sensor 1 >> Diagnostic Procedures

Diagnostic Procedures

  1. Perform On-Board Diagnostic (OBD) System Check. Read and record FREEZE FRAME and/or FAIL RECORDS data for each DTC set. Go to next step.
  2. Using scan tool, select LAST TST FAIL. Record any other failed DTCs. If any DTC other than P1133 or P1134 sets, diagnose affected DTC before proceeding. If no other DTC sets, start engine and allow it to idle. Operate vehicle within conditions required to set DTC. Using scan tool, read SPECIFIC DTC. If scan tool displays DTC P1133 FAILED THIS IGN, go to next step. If scan tool does not display DTC P1133 FAILED THIS IGN, go to DIAGNOSTIC AIDS.
  3. Check exhaust system for leaks. If exhaust leak is found, repair as necessary and go to step 11). If no exhaust leak is found, go to next step.
  4. Visually inspect HO2S 1 for secure installation or corrosion on terminals. Check terminal tension at HO2S 1 and PCM. Check for damaged wiring. If a problem is found, go to step 8). If no problem is found, go to next step.
  5. Disconnect HO2S 1 connector. Connect a jumper wire betweenHO2S 1 harness connector ground circuit and chassis ground. Using scan tool, read HO2S 1 voltage. If voltage is about 0.45 volt, go to next step. If voltage is not as specified, go to step 9).
  6. Connect a jumper wire between HO2S 1 harness connector signal and ground circuits, and chassis ground. If voltage is less than 0.3 volt, go to next step. If voltage is 0.3 volt or greater, go to step 10).
  7. Repair condition causing fuel, sealant, oil or coolant contamination. Replace affected HO2S and go to step 11).
  8. Repair condition as necessary and go to step 11).
  9. Repair open HO2S 1 ground circuit or HO2S 1 signal circuit shorted to ground, and go to step 11).
  10. Repair open HO2S 1 signal circuit or faulty PCM connections as necessary, and go to step 11).
  11. Using scan tool, read and record FAIL RECORDS DATA, and clear DTCs. Operate vehicle within conditions noted in FAIL RECORDS data. Using scan tool, select SPECIFIC DTC INFO for DTC P1133. If scan tool displays DTC P1133 FAILED THIS IGN, return to step 2). If scan tool does not display DTC P1133 FAILED THIS IGN, repair is complete.
scientia non olet · About LEMON Manuals