LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1996 >> Eighty-Eight Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Anti-Theft System >> Testing >> Pass-Key II(R) System Testing >> PASS-Key II(R) System Verification

PASS-Key II(R) System Verification

  1. Perform PASS-KEY II(R) DIAGNOSTIC SYSTEM CHECK. Ensure system will detect use of incorrect key by turning off engine. Disconnect PASS-Key II(R) 48-pin connector at base of steering column. Connect Interrogator (J 35628-A) to 48-pin connector. Set key code on interrogator to an incorrect key code. Attempt to start engine.
  2. If engine cranks, replace PASS-Key II(R) decoder module and repeat PASS-KEY II(R) DIAGNOSTIC SYSTEM CHECK. If engine does not crank within 3-minute lock-out period while SECURITY indicator is illuminated, turn ignition off. Disconnect interrogator and reconnect 48-pin connector at base of steering column. Attempt to start engine. If engine cranks, replace PASS-Key II(R) decoder module and repeat PASS-KEY II(R) DIAGNOSTIC SYSTEM CHECK.
  3. If engine does not crank, turn ignition off. Wait at least 3 minutes until end of lock-out period (SECURITY indicator will go out) and attempt to start engine. If engine does not start, see NOTES ON INTERMITTENTS  . If engine starts, system is functioning correctly. If an intermittent problem is suspected, see NOTES ON INTERMITTENTS.
scientia non olet · About LEMON Manuals