Fuel Injector(s)

Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See INJECTOR RESISTANCE SPECIFICATIONS table.

INJECTOR RESISTANCE SPECIFICATIONS⁽¹⁾

Application

Ohms

2.0L (VIN H)

11.8-12.6

2.2L (VIN 4)

1.6-12.4

2.3L (VIN A, D & 3 )

1.9-2.1

⁽¹⁾	Injector resistance specification is at 140°F (60°C).

NOTE: If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing PFI INJECTOR BALANCE TEST below.