B: Pass Key Decoder Module Test 2

Measure resistance at the PASS KEY DECODER MODULE CONNECTOR (Disconnected). The condition should be with no key in the ignition switch.

B: PASS KEY DECODER MODULE TEST 2⁽¹⁾

Measure Between

Correct Voltage

For Diagnosis

A6 (Purple/Yellow) & Ground

Open Circuit

See 1

A6 (Purple/White) & B2 (White/Black)

Open Circuit

See 2

⁽²⁾ A6 (Purple/Yellow) & B2 (White/Black)

In the range of 380 to 12.3 Kohms

See 3

⁽¹⁾	If resistance is correct but engine will not crank, replace the PASS Key Decoder Module.

⁽²⁾	Key in the ignition.

Check the Purple/Yellow (1074) wire for a short to ground. The short may be in the steering column.
Check the White/Black (1073) and Purple/Yellow (1074) wires for shorts between the two wires.
Check White/Black (1073) and Purple/Yellow (1074) wires for an open.