Preliminary Inspection

Verify customer complaint by operating system. Visually inspect for obvious signs of mechanical and electrical damage. Inspect for blown fuses and damaged relays. Inspect for loose or corroded connections, damaged wiring harnesses and/or switches. Check for a broken or partially broken wire inside insulation, which could cause system malfunction but prove good in a continuity/voltage check with system disconnected. Ensure any aftermarket electronic equipment is properly installed. If fault is found, repair as necessary. If no fault is found, perform system operation check. See SYSTEM OPERATION CHECK  .

1. Check WDO circuit breaker.
2. Check that ground G305 is clean and tight.
3. If motors internal circuit breaker trips, it will not reset until voltage is removed from the motor.