LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1985 >> Cutlass Cruiser 3.0 E >> Repair and Diagnosis >> Electrical >> Component Locations >> Electrical Component Locator >> Sending Units/Sensors

Sending Units/Sensors

SENDING UNITS/SENSORS LOCATION

Component Location
Barometric Pressure Sensor On firewall, at right side of blower motor.
Coolant Temp. Switch/Sending Unit On top of engine, below left side of valve cover (4-Cyl.), left of distributor (V6), or right side of engine below fuel filter (Diesel). See Figure.
Coolant Temperature Sensor On left center side of engine (4-Cyl.) or top of engine ahead of distributor (V6). See Figure.
Electronic Level Cont. Height Sensor On rear frame, near right rear shock (in front of fuel tank on Wagon).
Fuel Gauge Sending Unit At top of fuel tank.
Knock Sensor On top left of engine, below front of throttle body.
Manifold Absolute Pressure (MAP) Sensor On upper right engine cowl (4-Cyl.), right side of engine cowl behind shock tower (V6) or on left rear of engine (Diesel). See Figure.
Manifold Air Temp. (MAT) Sensor In air canister, at front of engine compartment.
Mass Airflow (MAF) Sensor Part of air intake duct.
Metering Valve Sensor (MVS) On top of engine.
Oxygen Sensor In exhaust manifold. See Figure.
Throttle Position Sensor On throttle body. See Figure.
Vehicle Speed Sensor (Pontiac 6000) On top right of transaxle.
Vehicle Speed Sensor (Except Pontiac 6000) Behind I/P.
Water-in-Fuel Sensor In fuel tank.