LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1977 >> Toronado Brougham >> Repair and Diagnosis >> Engine Performance >> Ignition System >> DELCO-REMY MISAR Ignition >> Overhaul >> Distributor >> Disassembly

DELCO-REMY MISAR Ignition: Overhaul: Distributor: Disassembly

  1. Remove cap and rotor. Mark distributor shaft and gear for reassembly reference. Drive out roll pin from drive gear while supporting gear to avoid damage to distributor shaft. Remove gear, shim and tanged washer from distributor shaft. Clean any burrs from shaft. Remove distributor shaft from housing.
  2. Remove 2 attaching screws and module. Remove washer from upper end of distributor housing. Remove lock ring at top of housing, shim, and felt washer. DO NOT attempt to service shaft bushings in housing.
  3. Disconnect capacitor lead, remove attaching screw and capacitor. Remove wiring harness from position in distributor housing. Remove 3 coil cover attaching screws and lift off cover. Remove 4 ignition coil attaching screws, disconnect coil leads, and remove coil from cap. Remove ignition coil and seal.
scientia non olet · About LEMON Manuals