Work Procedure

DESCRIPTION 

If only the around view monitor control unit is replaced, the calibration data stored in the camera can be written to the around view monitor control unit by selecting "Camera Calibration" of "Work Support" mode in CONSULT.

WORK PROCEDURE 

1. WRITE CALIBRATION DATA 

   With CONSULT

   1. Select "CALIBRATING CAMERA IMAGE" of "Work Support" mode using CONSULT.
   2. After displaying the status, check that the status is displayed as "Normal".

   Is the status of each camera displayed as "Normal"?

   YES>>

   INSPECTION END

   NO>>

   Calibrate the camera that is not displayed as "normal". Refer to Work Procedure .