Diagnosis Procedure
- CHECK DTC WITH COMBINATION METER
Refer to Diagnosis Description . Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Go to Refer to Work Flow .
- CHECK SNOW Mode SWITCH POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect 4WD switch assembly harness connector.
- Turn ignition switch ON.
- Check the voltage between 4WD switch assembly harness connector and ground.
4WD switch assembly Ground Voltage Connector Terminal M54 12 Ground Battery voltage
Is the inspection result normal?
YES>>
GO TO 4.
NO>>
GO TO 3.
- DETECT MALFUNCTIONING PART
Check the following.
- Fuse block harness connector M3
- 10 A fuse (No. 13)
- Harness for open or short between 4WD switch assembly and fuse.
>>
Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK SNOW Mode SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector.
- Check the continuity between 4WD switch assembly harness connector and combination meter harness connector.
4WD switch assembly Combination meter Continuity Connector Terminal Connector Terminal M54 22 M194 7 Existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES>>
GO TO 5.
NO>>
Repair open circuit, short to ground or short to power in harness or connector.
- CHECK SNOW Mode SWITCH
Refer to Component Inspection . Is the inspection result normal?
YES>>
GO TO 6.
NO>>
Replace 4WD switch assembly. Refer to CENTER CONSOLE ASSEMBLY : Removal and Installation .
- CHECK INTERMITTENT INCIDENT
Refer to Inspection .
>>
INSPECTION END
- CHECK DTC WITH COMBINATION METER
Refer to Diagnosis Description . Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Refer to Work Flow .
- CHECK SNOW Mode SWITCH POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect snow Mode/tow/Mode/VDC OFF switch assembly harness connector.
- Turn ignition switch ON.
- Check the voltage between snow Mode/tow/Mode/VDC OFF switch assembly harness connector and ground.
Snow Mode/tow/Mode/VDC OFF switch assembly Ground Voltage Connector Terminal M147 12 Ground Battery voltage
Is the inspection result normal?
YES>>
GO TO 4.
NO>>
GO TO 3.
- DETECT MALFUNCTIONING PART
Check the following.
- Fuse block harness connector M3
- 10 A fuse (No. 13)
- Harness for open or short between Snow Mode/tow/Mode/VDC OFF switch assembly and fuse.
>>
Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK SNOW Mode SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector.
- Check the continuity between snow Mode/tow/Mode/VDC OFF switch assembly harness connector and combination meter harness connector.
Snow Mode/tow/Mode/VDC OFF switch assembly Combination meter Continuity Connector Terminal Connector Terminal M147 22 M194 7 Existed - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES>>
GO TO 5.
NO>>
Repair open circuit, short to ground or short to power in harness or connector.
- CHECK SNOW MODE SWITCH
Refer to Component Inspection . Is the inspection result normal?
YES>>
GO TO 6.
NO>>
Replace snow Mode/tow/Mode/VDC OFF switch assembly. Refer to CENTER CONSOLE ASSEMBLY : Removal and Installation .
- CHECK INTERMITTENT INCIDENT
Refer to Inspection .
>>
INSPECTION END