Component Inspection

1. Turn ignition switch OFF.
2. Disconnect combination switch (spiral cable) harness connector M302.
3. Check resistance between combination switch harness connector terminals under the following conditions.

   Combination switch		Condition	Resistance (Ω)
   Connector	Terminals
   M302	16 and 17	MAIN switch: Pressed	Approx. 0
   		DYNAMIC DRIVER ASSISTANCE switch: Pressed	Approx. 270
   		CANCEL switch: Pressed	Approx. 620
   		DISTANCE switch: Pressed	Approx. 1, 100
   		SET/COAST switch: Pressed	Approx. 1, 810
   		RESUME/ACCELERATE switch: Pressed	Approx. 3, 000
   		All ICC steering switches: Released	Approx. 5, 420

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace ICC steering switch.