Configuration (BCM): Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing BCM. Refer to Work Procedure .

Configuration is as follows:

Function			Description
Vehicle Configuration	Before ECU Replacement		Reads the vehicle configuration of current BCM. Saves the read vehicle configuration.
	After ECU Replacement	EPC linked	NOTE: This item is displayed, but cannot be monitored.
	After ECU Replacement	Manual selection	Writes the vehicle configuration with manual selection.
Operation Log Selection			Writes the read vehicle configuration.

CAUTION:

When replacing BCM, always perform "Re/programming, Configuration" with CONSULT. Or not doing so, BCM control function does not operate normally.

Complete the procedure of "Re/programming, Configuration" in order.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
Never save vehicle configuration to BCM except for new BCM.
If you set incorrect vehicle configuration, incidents might occur.