Work Procedure

CAUTION:

Always use CONSULT for the decel G sensor calibration. (It cannot be adjusted other than with CONSULT.)

CHECK THE VEHICLE STATUS
1. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
2. Stop the engine.
3. Ignition switch OFF (Auto ACC function OFF).
Is the vehicle stopped in the straight-ahead position on level surface?

YES>>

GO TO 2.

NO>>

Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
PERFORM DECEL G SENSOR CALIBRATION
CAUTION:
- Never allow passenger or load on the vehicle.
- Never apply vibration to the vehicle body when opening or closing door during calibration.
With CONSULT
1. Ignition switch ON.
  CAUTION:
  Never start engine.
2. Select "ABS", "Work support", "DECEL G SENSOR CALIBRATION" in this order.
3. Select "START".
4. After approximately 10 seconds, select "END".
5. Ignition switch OFF (Auto ACC function OFF) and then it ON again.
  CAUTION:
  Be sure to perform the operation above.
>>

GO TO 3.
CHECK DATA MONITOR
With CONSULT
1. Drive the vehicle. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
2. Select "ABS", "Data Monitor", and "Decel G sensor" in this order. Check that the signal is within the specified value. Refer to Reference Value .
Is the inspection result normal?

YES>>

GO TO 4.

NO>>

GO TO 1.
ERASE SELF-DIAGNOSIS MEMORY
With CONSULT Erase self-diagnosis result of "ABS". Are the memories erased?

YES>>

End of work.

NO>>

Check the items indicated by the self-diagnosis.