Component Inspection

1. 1. Turn ignition switch OFF.
   2. Disconnect EOT sensor harness connector.
   3. Remove EOT sensor. Refer to Exploded View .
   4. Check the resistance between EOT sensor terminals by heating with hot water as shown in the figure, below.

      Courtesy of NISSAN

      EOT sensor		Condition		Resistance
      Terminal
      1	2	Temperature [°C (°F)]	20 (68)	2.37 - 2.63 kΩ
      			50 (122)	0.68 - 1.00 kΩ
      			90 (194)	0.236 - 0.260 kΩ

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace EOT sensor. Refer to Exploded View .