Work Procedure

After replacing the IPDM E/R, it is necessary to perform control unit configuration with CONSULT.

BEFORE REPLACEMENT

Before replacing IPDM E/R, save or print current vehicle specification with CONSULT vehicle configuration.

NOTE:

If the vehicle specifications cannot be saved, replace the IPDM E/R and then write the vehicle specifications by "Manual selection".

AFTER REPLACEMENT

When replacing IPDM E/R, write vehicle specification with CONSULT vehicle configuration.

CAUTION:

Never perform vehicle configuration other than performing with a new IPDM E/R or the control function may not operate normally.

SAVING VEHICLE SPECIFICATION
1. CONSULT
  1. Ignition switch ON.
  2. Select the "IPDM E/R" of "Re/programming, Configuration".
  3. Select the "Before ECU Replacement" of "Vehicle Configuration" to save current vehicle specification.
  NOTE: If vehicle specification cannot be saved with "Before ECU Replacement" of "Vehicle Configuration", perform "After ECU Replacement" of "Manual selection" to write vehicle specification.
>>

GO TO 2.
REPLACE IPDM E/R
1. 1. Ignition switch OFF.
  2. Replace IPDM E/R. Refer to Removal and Installation .
>>

GO TO 3.
WRITING VEHICLE SPECIFICATION
1. CONSULT
  1. Ignition switch ON.
  2. Select the "IPDM E/R" of "Re/programming, Configuration".
  3. Select the vehicle specifications saved with "Before ECU Replacement" and then write them to the replacement IPDM E/R. Refer to Work Procedure .
>>

Work End.