Detailed Flow
WARNING: This page is about a different car, the 2021 Nissan Rogue. However, it is still accessible from the selected car via links, so may be relevant.
- GET INFORMATION FOR SYMPTOM
Get the detailed information about symptom from customer.
GO TO 2.
- CHECK DTC
With CONSULT
- Check DTC of "All DTC Reading".
- Perform the following procedure if DTC is displayed.
- Record DTC and freeze frame data. (Or, write it down.)
- Check related service bulletins for information.
Is any DTCs detected?
YES
Perform the trouble diagnosis for DTC indicated.
NO
GO TO 3.
- CONFIRM THE SYMPTOM
Try to confirm the symptom described by the customer.
Also study the normal operation related to the symptom. Refer to Drive Mode Selector .
GO TO 4.
- CHECK DRIVE MODE SELECT SWITCH CIRCUIT
Check drive mode select switch circuit. Refer to Diagnosis Procedure .
Is inspection result normal?
YES
GO TO 5.
NO
Repair / replace harness or connector.
- CHECK DRIVE MODE SELECT SWITCH AND METER INDICATION
- Ignition switch OFF and wait at least 10 seconds.
- Ignition switch ON.
- Check that STANDARD is displayed on the information display screen of the combination meter. (2WD models)
- Check that AUTO is displayed on the information display screen of the combination meter. (AWD models)
- Check that the view of information display change when switching the drive mode select switch to up side or down side. (2WD models)
- Check that the view of information display change when switching the drive mode select switch to turn left or turn right. (AWD models)
Is the inspection result normal?
YES
INSPECTION END
NO
Perform intermittent incident. Refer to Intermittent Incident .