Work Procedure

WARNING: This page is about a different car, the 2021 Nissan Rogue. However, it is still accessible from the selected car via links, so may be relevant.

Perform action test to verify the customer's concern.
Perform action test and check the system operation after system diagnosis.

NOTE: Perform the Blind Spot Intervention system action test after checking that the I-LI system operates normally because the Blind Spot Intervention system shares components with the I-LI system.

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION: Fully understand the following items well before the road test;

System description: Refer to System Description .
Handling precaution: Refer to Precautions for Blind Spot Intervention .

LDW/I-LI SYSTEM ACTION TEST
Perform the LDW/I-LI system action test.
- LDW: Refer to System Description .
- I-LI: Refer to System Description .
GO TO 2.
CHECK BLIND SPOT INTERVENTION SYSTEM SETTING
1. Start the engine.
2. Check that the Blind Spot Intervention system setting can be enabled/disabled on the information display.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
INSPECTION END