Work Procedure

Perform the following procedures after replacing the around view monitor control unit.

1. REPLACE AROUND VIEW MONITOR CONTROL UNIT 
   1. Replace around view monitor control unit. Refer to Removal and Installation .

   >>

   GO TO 2.

2. WRITING MAC KEY 
   1. Perform MAC key writing. Refer to Description .

   >>

   GO TO 3.

3. PERFORM CONFIGURATION 
   CAUTION:

   CAUTION:  When before writing the around view monitor control unit configuration, always writing the MAC key.

   1. Perform configuration. Refer to Description .

   >>

   GO TO 4.

4. WRITING OF CALIBRATION DATA 
   1. Write the calibration data stored in the camera using CONSULT. Refer to Work Procedure .

   >>

   GO TO 5.

5. PERFORM SELF-DIAGNOSIS 
   1. 1. Perform the self-diagnosis of around view monitor control unit with CONSULT (AVM).
      2. Check if any DTC is detected.

   Is any DTC detected?

   YES>>

   Perform the trouble diagnosis for the detected DTC. Refer to DTC Index .

   NO>>

   GO TO 6.

6. OPERATION CHECK 
   1. Confirm that the operation of the intelligent around view monitor and the camera image (reference line, expected route) are normal.

   >>

   WORK END