Work Procedure

CHOOSE METHOD
1. There are two setting methods.
Which method do you choose?

With CONSULT >>

GO TO 2.

With set switch>>

GO TO 4.
WITH CONSULT - STEP 1
1. CONSULT Select "Work support" mode of "AUTO DRIVE POS.".
>>

GO TO 3.
WITH CONSULT - STEP 2
1. CONSULT
  1. Select "EXIT SEAT SLIDE SETTING", or "EXIT TILT SETTING" then touch display to change between ON and OFF.
    - EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)
    - EXIT TILT SETTING: Entry/exit assist (steering column)
  2. Select "SEAT SLIDE VOLUME SET" and touch either "40 mm", "80 mm", or "150 mm".
  3. Then select "OK".
>>

Inspection End.
WITH SET SWITCH - STEP 1
1. Ignition switch OFF.
>>

GO TO 5.
WITH SET SWITCH - STEP 2
1. Push set switch and hold for more than 10 seconds then confirm blinking of the memory switch indicator.
  - Entry/exit assist (seat/steering column) is ON: Memory switch indicator blinks two times.
  - Entry/exit assist (seat/steering column) is OFF: Memory switch indicator blinks once.
>>

Inspection End.