Decel G sensor calibration

CAUTION: Always use CONSULT for the decel G sensor calibration. (It cannot be adjusted other than with CONSULT.)

NOTE: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration.

CHECK THE VEHICLE STATUS
1. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
2. Stop the engine.
3. Ignition switch OFF.
Is the vehicle stopped in the straight-ahead position on level surface?

YES

GO TO 2.

NO

Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
PERFORM DECEL G SENSOR CALIBRATION
CAUTION:
- Never allow passenger or load on the vehicle.
- Never apply vibration to the vehicle body when opening or closing door during calibration.
CONSULT
1. Ignition switch ON.
  CAUTION: Never start engine.
2. Select "DECEL G SEN CALIBRATION " in "Work support " mode of "ABS ".
3. Select "Start ".
4. After approx. 10 seconds, select "End ".
5. Ignition switch OFF and then place it ON again.
  CAUTION: Be sure to perform the operation above.
GO TO 3.

CHECK DATA MONITOR

CONSULT

Drive the vehicle. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.

Select "ECU INPUT SIGNALS " and "DECEL G SENSOR " in "Data Monitor " mode of "ABS ". Check that the signal is within the specified value.

DECEL G SENSOR

: Approx. +/- 0.01 G

Is the inspection result normal?

YES

GO TO 4.

NO

GO TO 1.

ERASE SELF DIAGNOSTIC MEMORY
CONSULT

Erase "Self Diagnosis Result " mode of "ABS ".

Are the memories erased?

YES

Inspection End.

NO

Check the items indicated by the "Self Diagnostic Result ".