System Description: Description

Outline 

• The IPDM E/R incorporates a power consumption control function that reduces power consumption according to the vehicle status.
• The IPDM E/R changes its status (control mode) with the sleep wake up signal received from the BCM via CAN communication.

  Normal mode (wake-up):

  • CAN communication is normally performed with other control units.
  • Individual unit control by IPDM E/R is normally performed.

  Low power consumption mode (sleep):

  • Low power consumption control is active.
  • CAN transmission is stopped.

Sleep Mode Activation: 

• The IPDM E/R judges that the sleep-ready conditions are fulfilled when the ignition switch is OFF and none of the conditions below are present. Then it transmits a sleep-ready signal (ready) to the BCM via CAN communication.
  • Outputting signals to actuators
  • Switches or relays operating
  • Output requests are being received from control units via CAN communication.
• The IPDM E/R stops CAN communication and enters low power consumption mode when it receives a sleep wake up signal (sleep) from the BCM and the sleep-ready conditions are fulfilled.

Wake-up Operation: 

• The IPDM E/R changes from low power consumption mode to the normal mode when it receives a sleep wake-up signal (wake up) from the BCM or any of the following conditions are fulfilled. In addition, it transmits a sleep-ready signal (not-ready) to the BCM via CAN communication to report the CAN communication start.
  • Ignition switch ON.
  • An output request is received from a control unit via CAN communication.

Ignition Battery Saver Logic 

If the ignition is ON for a period of time with the engine OFF, the IPDM E/R and BCM turn OFF to save the battery.