LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2022 >> Frontier PRO-X >> Repair and Diagnosis >> Electrical >> Body Electrical >> Body Control System >> Basic Inspection >> Inspection And Adjustment >> Additional Service When Replacing Control Unit (BCM) >> Work Procedure

Work Procedure

  1. SAVING VEHICLE SPECIFICATION 

    SYMBOL CONSULT

    Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

    NOTE: If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

    GO TO 2.

  2. REPLACE BCM 

    Replace BCM. Refer to Removal and Installation .

    GO TO 3.

  3. WRITING VEHICLE SPECIFICATION 

    SYMBOL CONSULT

    1. Enter "Re/Programming, Configuration".
    2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to Work Procedure .
    3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .

    GO TO 4.

  4. REGISTER INTELLIGENT KEYS 

    SYMBOL CONSULT

    For initialization and registration of intelligent keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.

    NOTE: If customer has Virtual I-Key application, reprogram and register it as a third keyfob, and follow same configuration as vehicle Intelligent Key.

    GO TO 5.

  5. WRITING VEHICLE SPECIFICATION (TPMS) 

    SYMBOL CONSULT

    Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .

    GO TO 6.

  6. INITIALIZE TPMS 

    Perform TPMS initialization. Refer to Work Procedure .

    Work End.

scientia non olet · About LEMON Manuals