LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2022 >> Altima SL, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (ADAS Control Unit) >> Basic Inspection >> Configuration (ADAS Control Unit 2) >> Work Procedure

Work Procedure

WARNING: This page is about a different car, the 2022 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Use "Manual Configuration" only when "TYPE ID" of ADAS control unit 2 cannot be read.
  • If an error occurs during configuration, start over from the beginning.
  1. CHECKING PARTS NUMBER 

    SYMBOL CONSULT

    1. Select "Before Replace ECU" of "Read/Write Configuration".
    2. Check that "Parts number" is displayed on CONSULT.

    Is "Parts number" displayed?

    YES

    GO TO 2.

    NO

    GO TO 6.

  2. VERIFYING PARTS NUMBER (1) 

    SYMBOL CONSULT

    Compare "Parts number" displayed on the CONSULT screen with the one searched for using EPC (service parts catalog) to check that these "Parts number" agree with each other.

    NOTE: For the "Parts number" searched for using EPC (service parts catalog), use the last five digits of the "Parts number".

    GO TO 3.

  3. SAVING PARTS NUMBER 

    SYMBOL CONSULT

    Save "Parts number" on CONSULT.

    GO TO 4.

  4. REPLACE ADAS CONTROL UNIT 2 (1) 

    Replace ADAS control unit 2. Refer to Removal and Installation .

    GO TO 5.

  5. WRITING (AUTOMATIC WRITING) 

    SYMBOL CONSULT

    1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
    2. Select the "Parts number" agreeing with the one stored on CONSULT and the one searched for using EPC (service parts catalog) to write the "Parts number" into the ADAS control unit 2.

    GO TO 8.

  6. REPLACE ADAS CONTROL UNIT 2 (2) 

    Replace ADAS control unit 2. Refer to Removal and Installation .

    GO TO 7.

  7. WRITING (MANUAL WRITING) 

    SYMBOL CONSULT

    1. Select "Manual Configuration".
    2. Select the "Parts number" searched for using EPC (service parts catalog) to write the "Parts number" into the ADAS control unit 2.
      NOTE: For the "Parts number" searched for using EPC (service parts catalog), use the last five digits of the "Parts number".

    GO TO 8.

  8. VERIFYING PARTS NUMBER (2) 

    SYMBOL CONSULT

    Compare a "Parts number" displayed on the CONSULT screen with the one searched by using EPC (service parts catalog) to check that these "Parts number" agree with each other.

    NOTE: For the "Parts number" searched for using EPC (service parts catalog), use the last five digits of the "Parts number".

    GO TO 9.

  9. OPERATION CHECK 

    Confirm that each function controlled by ADAS control unit 2 operates normally.

    Work End.

scientia non olet · About LEMON Manuals