Total Toe-In Inspection

Measure total toe-in using following procedure:

1. Bounce front of vehicle up and down to stabilize vehicle height (posture).
2. Push on rear wheel to move vehicle straight ahead about 5 m (16 ft).
3. Put a mark on base line of tread (rear side) of both tires at same height as hub center. These are measuring points.

   Courtesy of NISSAN NORTH AMERICA, INC.

4. Measure distance (A) from rear side.

   Courtesy of NISSAN NORTH AMERICA, INC.

5. Push on rear wheel to move vehicle slowly ahead to rotate the wheels 180 degrees (1/2 turn).
   CAUTION: If wheels have rotated more than 180 degrees (1/2 turn), try above procedure again from beginning. Do not push vehicle backward.
6. Measure distance (B) from front side.
7. Use formula below to calculate total toe-in.

   Total toe-in formula	: A - B
   Total toe-in specification	: Refer to Wheel Alignment (Unladen) .

   • If total toe-in is outside specification, adjust total toe-in. Refer to Adjustment .