DTC Diagnosis Procedure

CONSULT

1. Ignition switch OFF to ON.
2. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
3. Ignition switch OFF and wait for at least 10 seconds.
4. Start the engine.
   CAUTION: Never drive the vehicle.
5. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

Is DTC "C1608-54" detected?

YES

EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation .

NO

Check pin terminal and connection of each harness connector for malfunctioning conditions.