LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Chassis Control System) >> Chassis Control >> DTC/Circuit Diagnosis >> C1BB4-00 Control Module >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO 2 .

  2. CHECK DTC DETECTION 

    SYMBOL CONSULT

    1. Turn the ignition switch OFF to ON.
      CAUTION: Be sure to wait 10 seconds after turning ignition switch OFF or ON.
    2. Select "Self diagnostic result" mode of "CHASSIS CONTROL".

    Is DTC "C1BB4-00" detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: Inspection End.

scientia non olet · About LEMON Manuals