Wake-up operation

BCM transmits sleep wake up signal (wake up) to each unit when any condition listed below is established, and then goes into normal mode from low power consumption mode.
Each unit starts transmissions with CAN communication by receiving sleep wake up signals. Each unit transmits wake up signals to BCM with CAN communication to convey the start of CAN communication.

Wake-up condition

Receiving the sleep-ready signal (Not-ready) from any units
Hazard switch: ON
HI BEAM switch: OFF -> ON, ON -> OFF
PASSING switch: OFF -> ON, ON -> OFF
HEADLAMP 1 switch: OFF -> ON, ON -> OFF
HEADLAMP 2 switch: OFF -> ON, ON -> OFF
TAIL LAMP switch: OFF -> ON
TURN RH: OFF -> ON, ON -> OFF
TURN LH: OFF -> ON, ON -> OFF
Driver door switch: OFF -> ON, ON -> OFF
Passenger door switch: OFF -> ON, ON -> OFF
Back door switch RH: OFF -> ON, ON -> OFF
Back door switch LH: OFF -> ON, ON -> OFF
Stop lamp switch: ON
Door lock and unlock switch:
NEUTRAL -> LOCK, NEUTRAL -> UNLOCK
Front door lock assembly (driver side) (door key cylinder switch):
NEUTRAL -> LOCK, NEUTRAL -> UNLOCK
Remote keyless entry receiver communication: Receiving